Chapter 5: Advanced Serverboard Setup
5-255-24
SUPERSTORAGESYSTEM 6038R-E1CR16H User's Manual
5-10 Onboard Indicators
LAN LEDs
The Ethernet ports (located beside the
VGA port) have two LEDs. On each
port, the green LED ashes to indicate
activity while the other LED may be
green, amber or off to indicate the
speed of the connection. See the table
on the right for the functions associ-
ated with the connection speed LED.
LAN1/2 LED
(Connection Speed Indicator)
LED Color Denition
Off No connection, 10 or 100 Mbps
Green 10 Gbps
Amber 1 Gbps
Onboard Power LED
An Onboard Power LED is located at
LE2. This LED Indicator is lit when
the system is on. Be sure to unplug
the power cable before removing or
adding any components. See the table
on the right for more details.
Dedicated IPMI LAN LEDs
A dedicated IPMI LAN is also located
on the I/O backplane. The amber LED
on the right indicates activity, while
the green LED on the left indicates
the speed of the connection. See the
table at right for more information.
BMC Heartbeat LED
A BMC Heartbeat LED is located at
LEDM1 on the serverboard. When
blinking, the BMC is functioning nor-
mally.
IPMI LAN Link LED (Left) &
Activity LED (Right)
Color/State Denition
Link (Left) Green: Solid 100 Mbps
Amber: Solid 1 Gbps
Activity (Right) Amber: Blinking Active
Onboard PWR LED Indicator
LED States
Color/State Denition
Off System Power Off
Green: On System Power On
BMC Heartbeat LED
States
Color/State Denition
Green: Blinking BMC Normal
5-11 SATA Ports
SATA Ports
There are ten SATA 3.0 ports included on the serverboard. Six ports (I-SATA 0-5)
are supported by the Intel PCH C612 while the other four are supported by the
Intel SCU and are located on a vertical S-SATA connector.
SAS Ports
An LSI 3008 controller card is included in the system to support up to 240 SATA
3.0/SAS 3.0 hard drives.
Note: For more information on SATA HostRAID conguration, please refer to the
Intel SATA HostRAID User's Guide posted on our website at http://www.supermicro.
com..
To Next Page
Loading...