Supermicro A2SAP-H - Quick Reference Table

13
Chapter 1: Introduction
Quick Reference Table
Jumper Description Jumper Setting (Default *)
JLCDPWR1
FORCE POWER ON
Pins 2-4* (FORCE POWER ON)
Pins 4-6 (POWER BUTTON ON)
LVDS Panel Power Source Selection
Pins 1-3* (3.3V)
Pins 3-5 (5V)
Connector Description
BT1
Battery Connector
(To Clear CMOS, remove the battery, short pins 1-2 and install the battery.)
I-SATA1 Intel® PCH SATA 3.0 Port
J3 Front Panel Audio Header (Mic-In/Line-out)
J6 Two USB 2.0 Headers
JCOM1 Two COM Headers (two RS232/422/485)
JDC 12V DC Jack Power Connector (for A2SAP-H)
JEIO1
Supermicro Extension I/O
(HDMI/DP, two PCI-E x1, two USB 2.0, LPC, SATA, SMBus, Power)
JF1 Front Control Panel Header (Power/HDD LED, Reset, Power button)
JGP1 8-bit General Purpose I/O Header
JHDMI1 High Denition Multimedia Interface (HDMI) Port
JLAN1/JLAN2 LAN1/LAN2 (RJ45 LAN) Ports
JMD1 M.2 Slot (B-KEY 2242/3042) (SATA 3.0 / PCI-E / USB 2.0)
JMP1 Mini PCI-E Slot (supports two PCIe Gen2 / one USB 2.0)
JPWR1 Two 4-pin 12V Power Connectors (for A2SAP-E/-L)
JSMBUS1 SMBus and 5V SATA Power Box Header
JUSB1 Two Back Panel USB 3.0 Ports
LVDS1 Dual Channel 48-bit LVDS Connector
SRW1 ~ SRW2 M.2 and Mini PCI-E Mounting Holes
Note: Components not documented are for internal testing only.