24
A2SAP-H/-E/-L User's Manual
SO-DIMM Installation
1. Position the SO-DIMM module's bottom key so it aligns with the receptive point on the
slot.
2. Insert the SO-DIMM module vertically at about a 45 degree angle. Press down until the
module locks into place.
Align
Insert this end rst Press down until the module
locks into place.
3. The side clips will automatically secure the SO-DIMM module, locking it into place.
Locking clip
SO-DIMM Removal
1. Push the side clips at the end of the slot to release the SO-DIMM module. Pull the SO-
DIMM module up to remove it from the slot.
To Next Page
Loading...
