Supermicro A2SAP-H - Chapter 4 BIOS - PCIe and CSM Configuration; PCIe;PCI;PnP Configuration; Mini PCIe OPROM Selection; M.2 OPROM Selection

Chapter 4: BIOS
69
PCIe/PCI/PnP Conguration
PCI Bus Driver Version A5.01.08
PCI Devices Common Settings:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space, if 64bit PCI
decoding is supported by the system. The options are Disabled and Enabled.
Mini PCIe OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
M.2 OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
Onboard LAN Option ROM Type
Use this feature to select which rmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
Onboard Video Option ROM
Use this feature to select which onboard video rmware type to be loaded. The options are
Disabled and EFI.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied Extensible
Firmware Interface) for network stack support. The options are Disabled and Enabled.
*If Network Stack is Enabled, the following four items will become available for
conguration:
Ipv4 PXE Support (Available when Network Stack is set to Enabled)
Select Enabled to enable Ipv4 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, Ipv4 PXE boot option will not be supported. The options are
Disabled and Enabled.
Ipv6 PXE Support (Available when Network Stack is set to Enabled)
Select Enabled to enable Ipv6 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, Ipv6 PXE boot option will not be supported. The options are
Disabled and Enabled.