3-7
Chapter 3: Installation
Using Basic EPCT Tool Commands in UEFI Environment
Follow the steps below to install and use EPCT Tool Commands in a UEFI envi-
ronment:
1. Download and unzip EPCT.zip to a removable drive.
2. Insert the removable drive into the system.
3. Select "UEFI: Built-in EFI Shell" from the boot menu.
4. In the UEFI shell, select the removable drive with the following command:
fs0:
Note: It is usually fs0, but can also be fs1,... etc.
5. Navigate to the EPCT\EFI2_x64 directory.
6. Find corresponding AOC-S100GC-i2C (E810-C) to NIC#. In this example,
AOC-S100GC-i2C NIC#=1. Run the following command to nd AOC-S100GC-
i2C NIC#:
epct64e.e -devices branding
To Next Page
Loading...
