Supermicro C9Z790-CG - Page 36

36
Super C9Z790-CG/-CGW User's Manual
3. Installation WITH pre-installed stando󰀨s:
Insert the M.2 device into the M.2 socket at a
30-degree angle and press it down.
Installation WITHOUT pre-installed stando󰀨s:
Install the stando󰀨 to the intended mounting hole rst. Then insert the M.2 device into
the M.2 socket at a 30-degree angle and press it down.
Tighten the M.2 device with the screw to secure the device into place.
4. Remove the thermal pad protective lm from
the M.2 heatsink.