Supermicro C9Z790-CG - Page 37

37
Chapter 2: Installation
5. To install the heatsink correctly, make sure
the pogo pin contacts are properly touching
the pogo pins on the motherboard. Refer to
the illustration on the right for the locations
of pogo pin contacts and pogo pin headers
(JLED_POGO1 and JLED_POGO2).
6. Resecure the M.2 heatsink in place with the
mounting screws removed in Step 1.
Pogo Pin Header
(JLED_POGO2
)
Pogo Pin Header
(JLED_POGO1)
Pogo Pin
Contacts
Heatsink with
LED for M.2-C1
Heatsink with
LED for M.2-P1
Pogo Pin
Contacts