Supermicro C9Z790-CG - Page 50

50
Super C9Z790-CG/-CGW User's Manual
Power LED Header
An onboard Power LED header is located at JLED1. This Power LED header is connected
to the Front Control Panel located at JF1 to indicate the status of system power. Refer to the
table below for pin denitions.
Power LED Header
Pin Denitions
Pin# Denition
1 VCC / POWER LED (+) in JF1
2 POWER LED (-) in JF1
3 POWER LED (-) in JF1
I/O Cover LED Board Connector
JLED_IO is a 4-pin connector to connect to the LED board pre-installed inside the I/O cover.
Refer to the table below for pin denitions.
I/O Cover LED Board Connector
Pin Denitions
Pin# Denition
1 VCC
2 NC
3 NC
4 Ground
1. Power LED Header
2. I/O Cover LED Board Connector
C9Z790-CGW
DESIGNED IN USA
REV:1.00
MAC CODEMAC CODE BAR CODE
BIOS
LICENSE
PCH
JLED_POGO2
JLED_POGO1
JRLED2
JRLED1
JTPM1
JLED_IO
SW1
JSTBY1
JD1
JSD1
JPW1
LED4801
LED18
LED17
LED1
LED3
LED2
JPW2
JL1
LED4
JPME2
JLED1
SYS_FAN1
SYS_FAN2
JWD1
22110
22110
2260
2280
PCH SLOT1 PCIe 3.0 X1
USB12 (3.2, 20Gb)
USB7 (3.2, 20Gb)
USB6 (3.2, 10Gb)
M.2-C1
12V_PUMP_PWR1
USB9 (3.2, 20Gb)
USB8 (3.2, 10Gb)
2280
SP1
B1
2260
2260
2280
BOOT LED
VGA LED
DIMM LED
CPU LED
DP/HDMI
LAN2
LAN1
JF1
AUDIO FP
COM1
USB4/5
USB10/11
(3.2, 5Gb)
M.2-P1
PCH SLOT5
PCIe
3.0 X1
CPU SLOT4
PCIe
5.0 X8 (IN X16)
CPU SLOT7
PCIe
5.0 X16
M.2-P2
SYS_FAN3
HD AUDIO
USB0/1/2/3
POWER
BUTTON
DIMMB1
DIMMB2
DIMMA1
DIMMA2
RESET
BUTTON
CPU_FAN1 CLEAR CMOS
CPU_FAN2
I-SATA4
I-SATA5
I-SATA2
I-SATA3
I-SATA0
I-SATA1
M.2-E1 (CNVi)
2
1