51
Chapter 2: Installation
Addressable RGB (ARGB) LED Connection Header
The motherboard has two +5V ARGB connection headers (JRLED1/2) for connection to
optional ARGB LED device such as an LED strip or LED fan. If connecting to an ARGB
LED fan, also connect the fan's power connector to one of the motherboard's fan headers
(SYS_FAN1 - SYS_FAN3).
ARGB LED Header
Pin Denitions
Pin# Denition
1 +5V
2 DATA
3 NC
4 Ground
Pogo Pin Header
The two pogo pin headers on the motherboard are used to provide power to the LED boards
of M.2 heatsinks. JLED_POGO1 is used for M.2-C1 heatsink LED board whilie JLED_POGO2
is for M.2-P1 heatsink LED board. With the heatsinks properly installed, the pogo pins will be
in direct contact with the pogo pin contacts inside the heatsinks.
Pogo Pin Header
Pin Denitions
Pin# Denition
1 5V
2 GND
1. JRLED1
2. JRLED2
3. JLED_POGO1
4. JLED_POGO2
C9Z790-CGW
DESIGNED IN USA
REV:1.00
MAC CODEMAC CODE BAR CODE
BIOS
LICENSE
PCH
JLED_POGO2
JLED_POGO1
JRLED2
JRLED1
JTPM1
JLED_IO
SW1
JSTBY1
JD1
JSD1
JPW1
LED4801
LED18
LED17
LED1
LED3
LED2
JPW2
JL1
LED4
JPME2
JLED1
SYS_FAN1
SYS_FAN2
JWD1
22110
22110
2260
2280
PCH SLOT1 PCIe 3.0 X1
USB12 (3.2, 20Gb)
USB7 (3.2, 20Gb)
USB6 (3.2, 10Gb)
M.2-C1
12V_PUMP_PWR1
USB9 (3.2, 20Gb)
USB8 (3.2, 10Gb)
2280
SP1
B1
2260
2260
2280
BOOT LED
VGA LED
DIMM LED
CPU LED
DP/HDMI
LAN2
LAN1
JF1
AUDIO FP
COM1
USB4/5
USB10/11
(3.2, 5Gb)
M.2-P1
PCH SLOT5
PCIe
3.0 X1
CPU SLOT4
PCIe
5.0 X8 (IN X16)
CPU SLOT7
PCIe
5.0 X16
M.2-P2
SYS_FAN3
HD AUDIO
USB0/1/2/3
POWER
BUTTON
DIMMB1
DIMMB2
DIMMA1
DIMMA2
RESET
BUTTON
CPU_FAN1 CLEAR CMOS
CPU_FAN2
I-SATA4
I-SATA5
I-SATA2
I-SATA3
I-SATA0
I-SATA1
M.2-E1 (CNVi)
1
3
4
2
To Next Page
Loading...
