Supermicro C9Z790-CG - Page 87

Chapter 4: UEFI BIOS
87
GT Voltage Mode
This feature controls the voltage mode in the GT domain. The options are Adaptive
and Override.
*If the feature of GT Voltage Mode is set to Adaptive, the following feature will
become available for conguration:
GT Extra Turbo Voltage
Enter a value for the extra turbo voltage (in mV) that will be applied while GT is
operating in turbo mode. The default is 0.
*If the feature of GT Voltage Mode is set to Override, the following features will
become available for conguration:
SVID
Use this feature to enable or disable the SVID. The options are Disabled and Enabled.
GT Voltage Override
Use this feature to specify the override voltage that will be applied to the GT domain
in millivolts. The default is 0.
GT Voltage O󰀨set
Enter a value for the o󰀨set voltage that will be applied to the GT domain in millivolts.
The default is 0.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The op-
tions are “+” and “-”.
Memory Prole
This feature controls the memory prole. The options are Default prole and Custom prole.
*If the Memory Profile feature is set to Custom profile, the following memory
congurations become available:
Memory Reference Clock
This feature controls the memory reference clock, in MHz. The options are 133 and 100.
Memory Frequency
Use this feature to set the frequency of the memory installed. The options are Auto and
DDR5-1000MHz to DDR5-8400MHz (in increments of 200MHz).