Supermicro C9Z790-CG - Page 91

Chapter 4: UEFI BIOS
91
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The options
are “+” and “-”.
*If the feature of VF Conguration Scope is set to Per-core, the following features will
become available for conguration:
P-core 0/1/2/3/4/5 Voltage O󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the performance-core
domain. The range is -500 to 500. The default is 0.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The options
are “+” and “-”.
*The features below are available when the Memory Prole is set to Custom prole.
Memory Voltage
Enter a value for the memory voltage override (Vdd) at DRAM side. 0 = no override. The
default is 1.100.
Memory Voltage VDDQ
Enter a value for the memory voltage override (Vddq) at DRAM side. 0 = no override. The
default is 1.100.
Memory Voltage VPP
Enter a value for the memory voltage override (Vpp) at DRAM side. 0 = no override. The
default is 1.800.
Advanced Voltage OC Setting
Voltage Conguration
VCCIN_AUX / VDD2_OC / Vcc_ST1 / Vcc_ST2
Enter a desired numeric value for each feature. The default of these features is Auto.
GT
GT Domain
GT OverClocking Frequency
Enter a value for the overclocked RP0 frequency (in multiples of 50 MHz) in the GT
domain. The default is 0.