Supermicro C9Z790-CG - Page 94

Super C9Z790-CG/-CGW User's Manual
94
Ring Voltage O󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the ring domain. The
range is -500 to 500 and the default is 0.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The op-
tions are “+” and “-”.
Uncore
Uncore Voltage Mode
Use this feature to select the Uncore voltage mode. In adaptive mode, the voltage is
interpolated only in turbo mode. In override mode, the voltage selected will be applied
over all operating frequencies. The options are Adaptive and Override.
*If the feature of Uncore Voltage Mode is set to Adaptive, the following feature will
become available for conguration:
Uncore Extra Turbo Voltage
Enter a value for the extra turbo voltage (in mV) that will be applied while SA Uncore
is operating in turbo mode. The default is 0.
*If the feature of Uncore Voltage Mode is set to Override, the following feature will
become available for conguration:
Uncore Voltage Override
Use this feature to specify the override voltage applied to the SA Uncore domain (in
mV). The default is Auto.
Uncore Voltage O󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the Uncore domain.
The range is -1000 to 1000 and the default is Auto.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The options
are “+” and “-”.