Supermicro C9Z790-CG - Page 93

Chapter 4: UEFI BIOS
93
*If the feature of E-Core L2 Voltage Mode is set to Override, the following feature
will become available for conguration:
E-core L2 Voltage Override
Use this feature to specify the override voltage applied to the E-core L2 domain (in
mV). The range is 0-2000 and the default is Auto.
E-Core L2 Voltage o󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the E-core L2 domain.
The range is -500 to 500 and the default is 0.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The op-
tions are “+” and “-”.
Ring
Ring Voltage Mode
Use this feature to select the CPU ring voltage mode. In adaptive mode, the voltage is
interpolated only in turbo mode. In override mode, the voltage selected will be applied
over all operating frequencies. The options are Adaptive and Override.
*If the feature of Ring Voltage Mode is set to Adaptive, the following feature will
become available for conguration:
Ring Extra Turbo Voltage
Use this feature to specify the extra turbo voltage applied while ring is operating in
turbo mode.
*If the feature of Ring Voltage Mode is set to Override, the following features
(SVID and Ring Voltage Override) will become available for conguration:
Ring Voltage Override
Use this feature to specify the override voltage applied to the ring domain (in mV).
The range is 0-2000 and the default is 0.
VF Point O󰀨set Mode
Use this feature to set VF Point O󰀨set mode. In Legacy mode, it sets a global o󰀨set
for the entire VF curve. In Selection mode, it sets a selected VF point. The options
are Legacy and Selection.