36
H13SSL-N/NT User's Manual
1. IPMI LAN Port
One IPMI LAN port is located on the I/O back panel. This port accepts an RJ45 type cable.
2~5. Universal Serial Bus (USB) Ports
There are four USB 3.0 ports (USB0/1 and USB2/3) on the I/O back panel. These support
the type A connector.
6~7. Gigabit LAN Ports
The H13SSL-NT has two Broadcom BCM57416 10GbE LAN ports and the H13SSL-N has
two Broadcom BCM5720L 1GbE LAN ports located on the I/O back panel. These ports accept
RJ45 type cables.
8. VGA Port
There is one VGA port on the rear I/O panel.
9. UID Switch and LED Indicator
A Unit Identier (UID) switch and UID LED are located on the I/O backpanel. The rear UID
LED is located next to the UID switch. When you press the UID switch, both rear and front
UID LED indicators will turn on. Press the UID switch again to turn o the LED indicators.
The UID Indicator provides easy identication of a system that may be in need of service.
Note: UID can also be triggered via IPMI on the serverboard. For more information on IPMI,
please refer to the IPMI User's Guide posted on our website at http://www.supermicro.com
To Next Page
Loading...
