Supermicro H13SSL-N - Page 50

50
H13SSL-N/NT User's Manual
Onboard Power OK LED (LED6)
LED6 is an onboard power OK LED. When this LED6 is lit, it means the system is turned
on, and all the system power rails are ready. When the system is turned o󰀨, or any one of
the system power rails fail, this LED will turn o󰀨. Turn o󰀨 the system, and unplug the power
cable before removing or installing any component(s).
Onboard Power
LED Indicator
LED Color Denition
O󰀨 System O󰀨 (power cable not connected)
Green System On, Power OK
M.2 Error LED (LED9 and LED11)
The M.2 Interface Detection LED indicates that an M.2 interface was detected and working
correctly on either M.2-C1 (LED9) or M.2-C2 (LED11). It will indicate whether a SATA or PCIe
signal has been detected.
M.2 Active
LED Indicator
LED Color Denition
O󰀨 O󰀨 (Normal)
Red On (SATA)