Supermicro H13SSL-N - Page 66

H13SSL-N/NT User's Manual
66
APBDIS
Use this setting to set APBDIS. Options include 0, 1 and Auto.
Power Prole Selection
Options include High Performance Mode, E󰀩ciency Mode and Maximum IO Performance
Mode.
DF Cstats
Use this setting to enable/disable DF Cstates. Options include Disabled, Enabled and Auto.
Data Link Feature Cap
Use this setting to set Data Link Feature Cap. Options include Enabled, Disabled and Auto.
SEV-SNP Support
Use this setting for SEV-SNP Support. Options include Disabled and Enabled.
Memory Conguration
Memory Target Speed
Use this feature to set the memory target speed. Options include Auto, DDR4800,
DDR5200 and DDR5600.
Memory Interleaving
This setting controls fabric level memory interleaving. Note that the channel, die and socket
have requirements on memory populations and it will be ignored if the memory doesn't
support the selected option. Options include Disabled and Auto.
Chipselect Interleaving
This setting controls interleave memory blocks across the DRAM chip for node 0. The
options are Disabled and Auto.
BankSwapMode
This setting controls the Bank Swap Mode. The options are Auto, Disabled and Swap CPU.
Power Down Enable
Use this setting to enable or disable DDR power down mode. The options are Disabled,
Enabled and Auto.
DRAM Scrub Time
This setting provides a value that is the number of hours to scrub memory. The options are
Disabled, 1 hour, 4 hours, 8 hours, 16 hours, 24 hours, 48 hours and Auto.
TSME
Transparent SME. The options are Disabled, Enabled and Auto.