3-1
Chapter 3
Setup and Installation
This chapter covers the setup and installation of the MicroBlade Ethernet switch
module.
SuperMicro has several 10-Gigabit and Gigabit Ethernet switch modules for its system.
moduless contain various external Ethernet uplinks. The following pages contain some
installation instructions that are common to all switches.
3-1 Installing/Removing a Switch Module
Follow the procedures below for installing or uninstalling a switch module into a
MicroBlade system.
Installing a Switch Module
1. Make sure the cover to the module has been installed before proceeding. Follow the
anti-static precautions described in Chapter 2.
2. Remove the dummy cover from the bay you want to place the module in.
3. Place the module's release handle in the open position.
4. Slide the module into the module bay until it stops (see Figure 3-1).
To Next Page
Loading...