Supermicro MicroBlade MBM-XEM-002 - MBM-GEM-004 Gigabit Ethernet Module LED Descriptions; Table A-2. MBM-GEM-004 Gigabit Ethernet Switch LED Indicators

6U/3U MicroBlade Network System Options User’s Manual
A-2
A-2 MBM-GEM-004 Gigabit Ethernet Module LED
Descriptions
MBM-GEM-004 Gigabit Ethernet module LEDs are described below in Table A-2.
Table A-2. MBM-GEM-004 Gigabit Ethernet Switch LED Indicators
LED State Description
Module Initiation OK
LED
Steady On
The MBM-GEM-004 GbE switch module is operational and has
passed the POST (Power-On Self-Test) with no critical faults.
Module Fault LED
(Red)
Steady On
When lit, this LED indicates that the MBM-GEM-004 GbE
switch module has either failed the POST or has detected an
operational fault within the module. When this LED is lit, the
fault LED on the blade enclosure will also turn on.
Link/Activity Ethernet
Port Status LED
Solid Green This indicates that the link is established, no activity
Blinking Green
This indicates that data is being transmitted (Tx) or received
(Rx)
Off This indicates that no link is established
Speed Ethernet Port
Status LED
Amber Connection speed of the port is 1-Gb/sec
Green Connection speed of the port is 100-Mb/sec
Off Connection speed of the port is 10-Mb/sec