3-7
Chapter 3: Setup and Installation
Address Defaults
The following defaults in Table 3-1 are the default addresses that are initially set.
Afterwards, you can change these values within the program.
NOTE: If two switches are installed in a MicroBlade system, you will have to change the IP
address of one from the default so that both switches have unique addresses.
Table 3-1. MBM-GEM-001 Switch Module Address Default Settings
Address Default Setting
Default IP Address https://192.168.100.102
Default Gateway Address 192.168.100.1
Default Subnet Mask 255.255.255.0
To Next Page
Loading...