3-5
Chapter 3: Setup and Installation
Note that any port may be configured as up (active) or down (inactive). All ports are
active by default.
Web-based Management Utility/IPMI
Using the Web-based Management Utility or IPMI is the most user-friendly method of
configuring the switch module. You can access the configuration menu either through
the management utility or by a network connection.
Network Connection
Use the procedure below to connect and login to the IPMI system.
Logging In to the IPMI:
1. Connect a PC to a network that is accessible to the switch.
For example, connect a PC to any of the front panel ports of the switch and make
sure the PC has an IP address on the same subnet as the switch management IP.
2. Type the IP address of the switch that you want to connect to in the address bar of
your browser, and hit <E
NTER>. Once the connection is made, the LOGIN screen
displays.
Figure 3-4. Blade Status Screen
a. Type in your Username in the U
SERNAME box.
b. Type in your Password in the PASSWORD box and click on LOGIN.
NOTE: The default username and the default password are both ADMIN. The default IP
address is https://192.168.100.100.
To Next Page
Loading...