3-3
Chapter 3: Setup and Installation
5. Push the release handle to the closed position.
NOTE: After the module has been installed and the handle locked, it will turn on and a POST
test will run to verify it is working properly. If there are no problems the blue Init. OK LED on
the module will illuminate and you will see an OK under I
NITIATED in the SWITCH screen of
the management software utility.
NOTE: If the module is installed in a top bay it must be positioned upside-down.
Figure 3-2. Blade Enclosure with Switch Modules Installed
MBM-GEM-001 Switch Module
MBM-XEM-001 Switch Module
To Next Page
Loading...