SBA-7121M-T1 Blade Module User’s Manual
1-2
1-3 Blade Module Features
Table 1-1 lists the main features of the SBA-7121M-T1 blade module. See the
proceeding section for components typically included in a blade system and other
optional components. Specific details on the SBA-7121M-T1 blade module is found in
Chapter 4: "Blade Module Features" on page 4-1.
Processors
The SBA-7121M-T1 blade module supports up to dual 771-pin Intel Xeon 2300/2200
series processors.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/superblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBA-7121M-T1 blade module are found
in Chapter 3: "Setup and Installation" on page 3-1.
Memory
The SBA-7121M-T1 blade module has eight 240-pin DIMM sockets that can support up
to 64 GB of ECC FBD (Fully Buffered DIMM) DDR2-800/667/533 SDRAM. Memory is
interleaved, which requires modules of the same size and speed to be installed in
groups (of two or three).
Please refer to the Supermicro web site for a list of supported memory
(www.supermicro.com/products/superblade). The detailed specifications for a blade
module will contain a link to a list of recommended memory sizes and manufacturers.
Details on installation of memory modules into the SBA-7121M-T1 blade module are
found in Chapter 3: "Setup and Installation" on page 3-1.
Table 1-1. SBA-7121M-T1 Blade Specification Features
Mainboard
BHDME (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32” x 1.67” x 18.5”
Processors
Supports Dual 1207-pin Socket F processors for up to two Six-Core AMD
Opteron™ series processors HT 3.0 Link support. Please refer to our web
site for a complete listing of supported processors.
FSB Speed Hyper Transport: 1000 MHz front side (system) bus speed
Chipset NVidia MCP55 Pro
Graphics Controller Onboard ATI ES1000 graphics chip with 16MB of SDRAM
BIOS 8 Mb AMI
®
Flash ROM
Memory Capacity
Eight 240-pin DIMM sockets supporting up to 64 GB of ECC Registered
DDR2-800/667/533 SDRAM DIMMS in two 4-DIMM slot banks.
SATA Controller NVidia MCP55 Pro on-chip controller for two Serial ATA drives
Hard Drive Bays Two (2) hot-swap drive bays for 3.5" SATA disk drives
To Next Page
Loading...
