Supermicro SBA-7121M-T1 - Event Log Configuration; PCI Express Configuration; Remote Access Configuration; Table 6-9. Event Log Configuration Submenu

SBA-7121M-T1 Blade Module User’s Manual
6-10
Event Log Configuration
The menu options in the EVENT LOG CONFIGURATION submenu and their descriptions are
shown in Table 6-9.
PCI Express Configuration
The PCI EXPRESS CONFIGURATION submenu contains a single menu option as shown in
Table 6-10.
Remote Access Configuration
The menu options in the REMOTE ACCESS CONFIGURATION submenu and their
descriptions are shown in Table 6-11.
Table 6-9. Event Log Configuration Submenu
Menu Option Description
View Event Log Highlight this item and press <ENTER> to view the contents of the event log.
Mark All Events as
Read
Highlight this item and press <ENTER> to mark all events as read.
Clear Event Log
Select Yes and press <E
NTER> to clear all event logs. The options are YES and
N
O to verify.
Table 6-10. PCI Express Configuration Submenu
Menu Option Description
Active State Power
Management
Used to E
NABLE or Disable the PCI L0 and L1 link power states.
Table 6-11. Remote Access Configuration Submenu
Menu Option Description
Remote Access
Allows you to ENABLE or Disable remote access. If enabled, the settings below
will appear.
Serial Port Number
Selects the serial port to use for console redirection. Options are COM1 and
COM2.
Serial Port Mode
Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,
N,
1), (38400 8,
N, 1), (19200 8, N, 1) AND (09600 8, N, 1).
Flow Control
Selects the flow control to be used for console redirection. Options are None,
H
ARDWARE and SOFTWARE.
Redirection After
BIOS POST
Options are D
ISABLE (no redirection after BIOS POST), BOOT LOADER
(redirection during POST and during boot loader) and Always (redirection
always active). Note that some OS's may not work with this set to Always.
Terminal Type Selects the type of the target terminal: ANSI, VT100 and VT-UTF8.