Supermicro SBA-7121M-T1 - Page 48

SBA-7121M-T1 Blade Module User’s Manual
6-8
Channel
Interleaving
Enables channel memory interleaving. Options include: Disabled, A
DDRESS BITS
6, A
DDRESS BITS 12, RESERVED, XOR OF ADDRESS BITS [20:16, 6], XOR OF
A
DDRESS BITS [20:16, 9].
Enable Clock to
All DIMMs
Use this setting to enable unused clocks to all DIMMs, even if some DIMM slots
are unpopulated. Options are E
NABLED and Disabled.
Mem Clk Tristate
C3/ALTVID
Use this setting to E
NABLE or Disable memory clock tristate during C3 and ALT
VID.
Memory Hole
Remapping
When ENABLED, this feature enables hardware memory remapping around the
memory hole. Options are Enabled and D
ISABLED.
CS Sparing
Enable
Use this setting to E
NABLE or Disable the CS Sparing function.
DCT Unganged
Mode
This allows selection of unganged DRAM mode (64-bit width). Options are Auto
(Ganged Mode) and A
LWAYS (unganged mode).
Power Down
Enable
Enable or D
ISABLE DDR power down mode.
Power Down
Mode
Set DDR power down mode to Channel or CHIP SELECT.
X ECC Configuration
ECC Mode
DRAM ECC allows hardware to report and correct memory errors automatically.
Options are Enabled and D
ISABLED.
• 4-Bit ECC Mode – Allows you to enable 4-bit ECC mode (also known as
ECC Chipkill). Options are E
NABLED and Disabled.
• DRAM Scrub Redirect – Allows the system to correct DRAM ECC errors
immediately, even with background scrubbing on. Options are E
NABLED and
Disabled.
• DRAM BG Scrub – Corrects memory errors so later reads are correct.
Options are Disabled and various times in nanoseconds and
microseconds.
Alternate VID
Specifies and alternate VID while in low power states. Options are Auto and
various voltages between .8V and 1.115V.
Memory Timing
Parameters
Allows the user to select which CPU Node's timing parameters (memory clock,
etc.) to display. Options are CPU Node 0, CPU N
ODE 1, CPU NODE 2 and CPU
N
ODE 3.
X DRAM Timing Configuration
Memory Clock
Mode
Set the Memory Clock Mode. Options are Auto, LIMIT and MANUAL.
DRAM Timing
Mode
Set the DRAM Timing Mode. Options are Auto, DCTO, DCT1 and B
OTH.
Table 6-7. NorthBridge Configuration Submenu (Continued)
Menu Option Description