Supermicro Supero X9DRi-LN4F+ - Page 13

Chapter 1: Overview
1-5
X9DR3-LN4F+/X9DRi-LN4F+ Jumpers
Jumper
Description Default Setting
JBT1
Clear CMOS See Chapter 2
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Pins 2-3 (Normal)
JPB1 BMC Enabled Pins 1-2 (Enabled)
JPG1 VGA Enabled Pins 1-2 (Enabled)
JPL1 GLAN1/GLAN2 Enable Pins 1-2 (Enabled)
JPME1 Management Engine (ME)
Recovery Mode Enable
Pins 1-2 (Normal)
JPME2 Management Engine (ME)
Manufacture Select
Pins 1-2 (Normal)
JWD Watch Dog Pins 1-2 (Reset)
X9DR3-LN4F+/X9DRi-LN4F+ Connectors
Connectors Description
COM1/COM2 Backplane COM Port1/Front Accessible COM2 Header
CPU1 Slot1/Slot3
CPU2 Slot4/Slot5
PCI-E 3.0 x16 Slots (CPU1 Slot1/CPU1 Slot3, CPU2 Slot4/
CPU2 Slot5)
CPU2 Slot6 PCI-E 3.0 x8 Slot
CPU1 Slot2 PCI-E 3.0 x4 in x8 Slot
FAN1~6, FANA,
FANB
CPU/System Fan Headers
IPMB 4-pin External BMC I
2
C Header (for an IPMI Card)
I-SATA 0~5 Intel SB SATA Connectors 0~5 (6 SATA Ports on X9DR3-
LN4F+, 4 SATA Ports on X9DRi-LN4F+)
J17/J18 Serial-Link General_Purpose IO Headers (T-SGPIO 1/2)
JBAT1 Onboard Battery (See Chpt. 4 for Used Battery Disposal)
JD1 Speaker/Power LED Indicator
JF1 Front Panel Control Header
JPI
2
C1 System Management SMBbus I
2
C Header
JL1 Chassis Intrusion
JOH1 Overheat/Fan Fail LED
JPI
2
C1 Power Supply SMBbus I
2
C Header
JPW1 ATX 24-Pin Power Connector (See Warning on Pg. 1-6.)
JPW2/JPW3 12V 8-Pin Power Connectors (See Warning on Pg. 1-6.)
JSD1 SATA DOM (Device_On_Module) Power Connector
JSTBY1 Standby Header