EasyManua.ls Logo

Supermicro Supero X9DRi-LN4F+ - Page 91

Supermicro Supero X9DRi-LN4F+
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 4: AMI BIOS
4-17
to allow the system BIOS to automatically set the ASPM level for the system. Select
Disabled to disable ASPM support. The options are Disabled, Force L0, and Auto.
Warning: Enabling ASPM support may cause some PCI-E devices to fail!
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G
Address. The options are Enabled and Disabled.
SMBus Address Resolution Protocol
Select Enabled to dynamically assign a new unique address to a device installed
in each slave drive in the SMBus (System Management Bus) when a address
conict arises to resolve an address conict in SMBus slave drives. The options
are Enabled and Disabled.
CPU1 Slot 1 PCI-E 3.0 x16 OPROM/CPU1 Slot 2 PCI-E 3.0 x4 OPROM/CPU1
Slot 3 PCI-E 3.0 x16 OPROM/CPU2 Slot 4 PCI-E 3.0 x16 OPROM/CPU2 Slot
5 PCI-E 3.0 x16 OPROM/CPU2 Slot 6 PCI-E 3.0 x8 OPROM
Select Enabled to enable Option ROM support to boot the computer using a
network interface from the slots specied above. The options are Enabled and
Disabled.
Onboard LAN Option ROM Select
Select iSCSI to use the iSCSI Option ROM to boot the computer using a network
device. Select PXE (Preboot Execution Environment) to use an PXE Option ROM
to boot the computer using a network device. The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM/ Load
Onboard LAN3 Option ROM/Load Onboard LAN4 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM.
This is to boot the computer using a network device. The default setting for LAN1
Option ROM is Enabled, and the default settings for LAN2 Option ROM/LAN3
Option ROM/LAN4 Option ROM are Disabled.
VGA Priority
Use this feature to select the graphics adapter to be used as the primary boot
device. The options are Onboard and Offboard.
Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.

Table of Contents

Related product manuals