Supermicro Supero X9SCA - Nic1;Nic2 (Lan1;Lan2); Overheat (Oh);Fan Fail; UID LED

Chapter 2: Installation
2-23
NIC1/NIC2 (LAN1/LAN2)
The NIC (Network Interface Controller)
LED connection for LAN port 1 is located
on pins 11 and 12 of JF1, and the LED
connection for LAN Port 2 is on Pins 9
and 10. NIC1 LED and NIC2 LED are
2-pin NIC LED headers. Attach NIC LED
cables to NIC1 and NIC2 LED indicators
to display network activities. Refer to the
table on the right for pin denitions.
LAN1/LAN2 LED
Pin Denitions (JF1)
Pin# Denition
9/11 Vcc
10/12 Ground
C
A. NIC1 LED
B. NIC2 LED
C. OH/Fan Fail / UID LED
OH/Fan Fail LED
Pin Denitions (JF1)
Pin# Denition
7 Vcc/Blue UID LED
8 OH/Fan Fail LED
OH/Fan Fail Indicator
Status
State Denition
Off Normal
On Overheat
Flash-
ing
Fan Fail
A
B
Overheat (OH)/Fan Fail / UID LED
Connect an LED cable to the OH/Fan
Fail connections on pins 7 and 8 of JF1
to display signals or to provide advanced
warnings for chassis overheat/fan failure.
Refer to the table on the right for pin de
nitions. Refer to page 2-31 for information
on UID-LED.
Power Button
OH/Fan Fail LED
1
NIC1 LED
Reset Button
2
HDD LED
Power LED
Reset
PWR
LED_Anode+
LED_Anode+
LED_Anode+
LED_Anode+
Ground
Ground
NIC2 LED
LED_Anode+
PWR Fail
UID-LED