Supermicro Supero X9SCA - Jumper Settings; Explanation of Jumpers; LAN Port Enable;Disable (JPL1~4)

2-32
X9SCi-LN4/X9SCi-LN4F/X9SCA/X9SCA-F
2-7 Jumper Settings
Explanation of Jumpers
To modify the operation of the mother-
board, jumpers can be used to choose
between optional settings. Jumpers create
shorts between two pins to change the
function of the connector. Pin 1 is identied
with a square solder pad on the printed
circuit board.
Note: On two pin jumpers,
"Closed" means the jumper is on,
and "Open" means the jumper is
off the pins.
A. LAN Port 1 Enable
B. LAN Port 2 Enable
C. LAN Port 3 Enable
D. LAN Port 4 Enable
LAN Port Enable/Disable (JPL1~4)
Jumpers JPL1/JPL2 enable or disable
LAN Port 1/LAN Port 2 on the moth-
erboard. See the table on the right for
jumper settings. The default setting is
enabled. JPL3/JPL4 are available only on
the X9SCi-LN4/-LN4F.
GLAN Enable
Jumper Settings
Pin# Denition
1-2 Enabled (default)
2-3 Disabled
B
A
D
C