Supermicro SuperServer 2049U-TR4 - Page 62

62
SuperServer 2049U-TR4 User's Manual
Power-Failure Throttling Enable/Disable


setting table below.
Power-Failure Throttling
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Normal
Management Engine (ME) Recovery
            
allocation for essential system operation only in order to maintain normal power operation
and management. In the single operation mode, online upgrade will be available via Recovery

Manufacturer Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 ME Recovery
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the
application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port, which is supported by the onboard BMC
controller. The default setting is Enabled.