5-8
SUPERSERVER 5018R-M/5018R-MR User's Manual
5-5 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules
to prevent any possible damage.
Installing DIMMs
Insert the desired number of DIMMs into the memory slots, starting with slot
DIMMA1.
1. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
2. Align the key on the DIMM module with the receptive point on the slot.
3. Use two thumbs together to press on both ends of the module straight down
into the slot until the module snaps into place.
4. Press the release tabs to the lock positions to secure the DIMM module into
the slot. Reverse the above steps to remove DIMMs. See Figure 5-5.
Memory Support
The X10SRi-F supports up to 1 TB of ECC 3DS LRDIMM (Load-Reduced DIMM),
512 GB of ECC LRDIMM or 256 GB of ECC RDIMM (Registered DIMMs) DDR4-
2400/2133/1866/1600 memory.in eight memory slots. Please refer to the table on
the following page and the Supermicro website for possible updates to memory
support.
Figure 5-5. Installing a DIMM into a Slot
Socket Key
To Next Page
Loading...
