5-10
SUPERSERVER 5018R-M/5018R-MR User's Manual
5-6 Adding PCI Cards
PCI Expansion Slots
One riser card is used to support a PCI expansion (add-on) card in the system. The
system can accommodate one standard size (full height full length) PCI expansion
card. When viewed from the chassis front, the card installs to the left rear of the
system.
PCI Card Installation
Before installing a PCI add-on card, make sure it is supported by the riser card.
Begin by releasing the locking tab that corresponds to the slot you wish to populate.
Insert the expansion card into the riser card by pushing down with your thumbs
evenly on both sides of the card.
PCI Slot/Card Conguration
Riser Card Expansion card supported
RSC-RR1U-E16 (pre-installed) One PCI-E 3.0 x16
To Next Page
Loading...
