Supermicro SUPERSERVER 6029BT-HNC0R - Installing Expansion Cards

SuperServer 6029BT-HNC0R User's Manual
48
Installing Expansion Cards

Installing a Full-Height Expansion Card
1. Power down the node and remove it from the chassis.
2. Remove the screws holding the riser card brackets.
• For the right side (looking from the node rear), remove the three screws on the right.
• For the left side, remove the three screws on the left.
3. Remove the blank PCI shield from the chassis.
4. Slide the expansion card shield into the open shield slot while plugging the expansion
card into the riser card.
5. Replace the screws.
Figure 3-13. Installing the Expansion Cards
Riser Card
Bracket screw
Riser Card
Bracket screw
Riser Card
Bracket screw
Riser Card
Bracket screw
Riser Card
Bracket screw
Riser Card
Riser Card