WIT.RU
WIT Company – поставка серверов, СХД,
сетевого оборудования, лицензионного ПО
SuperServer 6029P-WTR User's Manual
38
Figure 3-6. Removing a Dummy Drive and Slot Cover
Figure 3-5. Mounting a Drive into a Carrier
Installing an Optional Fixed Hard Drive
The SC825TQC chassis includes two open slots for optional hard disk drives. To utilize these
slots, the dummy drive and the slot cover must be removed.
Removing the Dummy Drive or Hard Disk Drive
1. Begin by removing power from the system as described in section 3.1 and the chassis
cover as described in section 3.2..
2. Press the release tab.
3. Push against the back of the dummy drive, sliding the dummy drive and slot cover
forward, out through the front of the chassis.
4. Insert the drive into rear of the open slot and connect the wiring.
Release Tabs
3
2
To Next Page
Loading...
