Supermicro SuperServer E50-9AP-N5 - Page 26

26
SuperServer E50-9AP-N5 User's Manual
Battery Connector
BT1 is a two-pin connector for an external CMOS battery. Refer to Chapter 2 for battery
installation instructions. This connector is also used to clear the CMOS. To clear the CMOS,
remove the battery, short pins 1-2 and then re-install the battery.
LVDS Connector
󰀨
interface that operates at low power. It is a type of connection that is used with a LVDS LCD
panel.
LVDS Connector
Pin Denitions
Pin# Denition Pin# Denition
39 GND 40 GND
37 LVDSB D3N 38 LVDSB D3P
35 LVDSB CLKN 36 LVDSB CLKP
33 LVDSB D2N 34 LVDSB D2P
31 LVDSB D1N 32 LVDSB D1P
29 LVDSB D0N 30 LVDSB D0P
27 GND 28 GND
25 LVDSA D3N 26 LVDSA D3P
23 LVDSA CLKN 24 LVDSA CLKP
21 LVDSA D2N 22 LVDSA D2P
19 LVDSA D1N 20 LVDSA D1P
17 LVDSA D0N 18 LVDSA D0P
15 BKLTEN 16 GND
13 BKLTCTL 14 PVCCEN
11 DDC CLK 12 DDC DATA
9 LCDVCC 10 LCDVCC
7 3.3V 8 GND
5 12V 6 GND
3 12V 4 12V
1 12V 2 12V