Supermicro X11SCA - Page 111

Appendix D: UEFI BIOS Recovery
111
Note: If the following screen displays, please load the "Super.ROM" le to the root
folder and connect this folder to the system. You can do so by inserting a USB device
that contains the new "Super.ROM" image to your machine for BIOS recovery.
The le system supported by UEFI is FAT (including FAT12, FAT16, and FAT32) installed on
a bootable or non-bootable USB-attached device. However, the BIOS might need several
minutes to locate the SUPER.ROM le if the media size becomes too large because it contains
too many folders and les.
To perform UEFI BIOS recovery using a USB-attached device, follow the instructions below.
1. Using a different machine, copy the "Super.ROM" binary image le into the disc Root "\"
Directory of a USB device or a writeable CD/DVD.
Note: If you cannot locate the "Super.ROM" le in your driver disk, visit our website
at www.supermicro.com to download the BIOS image into a USB ash device and
rename it to "Super.ROM" for BIOS recovery use.
2. Insert the USB device that contains the new BIOS image ("Super.ROM") into your USB
drive and power on the system
3. After locating the new BIOS binary image, the system will enter the BIOS Recovery
menu automatically as shown below.