Supermicro X11SCA - Page 38

38
X11SCA/-W/-F User Manual
Universal Serial Bus (USB) Ports
There are two USB 3.1 Gen 1 ports (USB2/3) and
two USB 3.1 Gen 2 ports (USB6/7) located on the
I/O back panel. The motherboard also has two
front access USB headers (USB0/1 (USB2.0) and
USB4/5 (USB3.1 Gen 1)) and two front access USB
3.1 header (USB8 and USB9). The USB8 header is
Type-C and USB9 is Type-A. The onboard headers
can be used to provide front side USB access with
a cable (not included).
Note: USB wake up capabilities are limited
to the USB0/1 header and USB7 port. USB
wake up is enabled by default in BIOS. Dis-
abling this feature must be completed in the
operating system.
Front Panel USB (2.0) 0/1, 4/5
Pin Definitions
Pin# Denition Pin# Denition
1 +5V 2 +5V
3 USB_N 4 USB_N
5 USB_P 6 USB_P
7 Ground 8 Ground
9 Key 10 NC
Type A USB 9 (3.1 Gen 1)
Pin Definitions
Pin# Denition Pin# Denition
1 VBUS 5 SSRX-
2 USB_N 6 SSRX+
3 USB_P 7 GND
4 Ground 8 SSTX-
9 SSTX+
Back Panel USB 2/3 (3.1 Gen 1)
Pin Definitions
Pin# Denition Pin# Denition
A1 VBUS B1 Power
A2 D- B2 USB_N
A3 D+ B3 USB_P
A4 GND B4 GND
A5 Stda_SSRX- B5 USB3_RN
A6 Stda_SSRX+ B6 USB3_RP
A7 GND B7 GND
A8 Stda_SSTX- B8 USB3_TN
A9 Stda_SSTX+ B9 USB3_TP
COM1
JBT1
B3
USB0/1 (2.0)
JPAC1
JPME2
JF1
JLED1
CPU SLOT6 PCI-E 3.0 X16
PCH SLOT2 PCI-E 3.0 X4
PCH SLOT7 PCI-E 3.0 X1
SLOT1 PCI 33MHZ
JWD1
JTBT1
CPU
PCI-E_M.2-M2
PCI-E_M.2-M1
I-SATA5
I-SATA3
I-SATA1
CMOS CLEAR
I-SATA4
I-SATA2
I-SATA0
I-SATA7
I-SATA6
U.2-1
USB4/5 (3.0)
USB8 (3.1,TypeC)
USB9 (3.1,TypeA)
SYS_FAN2
JPW1
SYS_FAN1
CPU_FAN1
JVR1
DIMMA1
DIMMA2
DIMMB1
DIMMB2
CPU_FAN2
SYS_FAN3
JPW2
JPL1
DVI
DP
HDMI
USB2/3(3.0)
USB6/7(3.1)
LAN1
LAN2
AUDIO
JPL2
I-SGPIO1
I-SGPIO2
JSTBY1
SPKR
SP1
JTPM1
AUDIO_FP
JPI2C1
CPU SLOT4 PCI-E 3.0 X8 (IN X16)
JL1
JSD1
LED_PWR_SB
1. USB0/1
2. USB2/3
3. USB4/5
4. USB6/7
5. USB8
6. USB9
1
2
5
6
4
3