Supermicro X11SCA - Page 76

X11SCA/-W/-F User Manual
76
Maximum Memory Frequency
This feature selects the type/speed of the memory installed. The options are 1333, 1600,
1867, 2133, 2400, 2667, 2933, and 3200. All values are in MHz. Default speed is auto
detected.
ECC Support
This feature enables DDR ECC support. The options are Disabled or Enabled.
Max TOLUD
This feature sets the maximum TOLUD value, which species the “Top of Low Usable
DRAM” memory space to be used by internal graphics devices, GTT Stolen Memory,
and TSEG, respectively, if these devices are enabled. The options are Dynamic, 1 GB
~ 3.5 GB (in 0.25 GB increments).
Memory Scrambler
This feature enables memory scrambler support for memory error correction. The set-
tings are Disabled or Enabled.
MRC Fast Boot
This feature enables fast path through MRC. The settings are Disabled or Enabled.
REFRESH_2X_MODE
This feature controls the 2xRef mode. The options are Disabled, 1 (Enabled WARM/
HOT), and 2 (Enabled HOT).
Closed Loop Therm Manage
This feature enables Closed Loop Thermal management. The options are Disabled or
Enabled.
Graphics Conguration
Primary Display
This feature controls which graphics device will be used as the primary display. The op-
tions are Auto, IGFX, PEG, PCI, and SG.
Primary PEG
This feature controls the graphics device to be used as the primary device. The options
are CPU SLOT6 PCI-E 3.0 X16 or CPU SLOT4 PCI-E 3.0 X8 (IN X16).
Primary PCIE
This feature controls the primary PCIE device. The options are Auto, OnBoard, PCH
SLOT2 PCI-E 3.0 X4, and PCH SLOT7 PCI-E 3.0 X1.
Internal Graphics
This feature enables internal graphics support, based on the setup options. The options
are Auto, Disabled, and Enabled.