Supermicro X11SCA - Page 88

X11SCA/-W/-F User Manual
88
EMS Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by buffer overow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits
Parity
Stop Bits
SATA And RST Conguration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled or Enabled.
SATA Mode Selection
This feature controls the SATA mode. The options are AHCI or RAID.
Aggressive LPM Support
This feature enables the PCH to aggressively enter link power state. The options are Disabled
or Enabled.
Storage Option ROM/UEFI Driver
This feature controls the execution of UEFI and legacy storage OpROM. The options are Do
not launch, UEFI, and Legacy.
Serial ATA Port 0~7
Hot Plug
This feature designates the port specied for hot plugging. Set this item to Enabled for
hotplugging support, which will allow the user to replace a SATA disk drive without shutting
down the system. The options are Disabled or Enabled.
Spin Up Device
When this feature is disabled, all drives will spin up at boot. When this option is enabled, it will
perform Staggered Spin Up on any drive this option is activated. The settings are Disabled
or Enabled.
SATA Device Type
Use this feature to identify the type of HDD that is connected to the SATA port. The options
are Hard Disk Drive or Solid State Drive.