Supermicro X12SPZ-SPLN6F - Page 112

Super X12SPZ-SPLN6F/LN4F User's Manual
112
iSCSI General Parameters
TCP/IP Parameters via DHCP
Use this feature to acquire the TCP/IP conguration via DHCP. The options are Disabled
and Enabled.
iSCSI Parameters via DHCP
Use this feature to acquire the iSCSI parameters via DHCP. The options are Disabled
and Enabled.
CHAP Authentication
Use this feature to enable or disable CHAP authentication. The options are Disabled
and Enabled.
Boot to iSCSI Target
Use this feature to enable or disable booting to iSCSI target after logon. The options are
Disabled, Enabled, and One Time Disabled.
DHCP Vendor ID
Use this feature to congure the DHCP vendor ID, which can be up to 32 characters long.
Link Up Delay Time
Use this feature to congure the link up delay time (in seconds). The default value is 0.
Use TCP Timestamp
Use this feature to enable or disable the TCP timestamp. The options are Disabled and
Enabled.
Target as First HDD
Use this feature to enable or disable if the target appears as rst HDD in the system.
The options are Disabled and Enabled.
LUN Busy Retry Count
Use this feature to congure the number of retries in two second-intervals when LUN is
busy. The default value is 0.
IP Version
Use this feature to select the IP version. The options are IPv4 and IPv6.