Supermicro X12SPZ-SPLN6F - Page 120

Super X12SPZ-SPLN6F/LN4F User's Manual
120
When SEL is Full
This feature allows you to decide what the BIOS should do when the system event log is full.
Select Erase Immediately to erase all events in the log when the system event log is full. The
options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, reboot the system for the changes to take
e󰀨ect.
BMC Network Conguration
BMC Network Conguration
Update IPMI LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If the feature above is set to Yes, Conguration Address Source, VLAN, and IPv6
Support are available for conguration:
Congure IPv4 Support
IPMI LAN Selection
IPMI Network Link Status
Conguration Address Source
This feature allows you to select the source of the IP address for this computer. If Static is
selected, you will need to know the IP address of this computer and enter it to the system
manually in the eld. If DHCP is selected, the BIOS will search for a DHCP (Dynamic
Host Conguration Protocol) server in the network that is attached to and request the next
available IP address for this computer. The options are DHCP and Static.
*If the feature above is set to Static, the following features are available for
conguration:
Station IP Address
This features displays the Station IP address for this computer. The address can be
manually entered. This should be in decimal and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The address can be
manually entered. The value of each three-digit number separated by dots should not
exceed 255.