Supermicro X12STL-F - Page 98

Super X12STL-F User's Manual
98

This section displays the following information if a storage device is detected by the system.
• HDD Name
• HDD Serial Number
• Security Mode
• Estimated Time
• Admin Pwd Status
Security Function
Select "Set Password" to set an HDD/SATA password, which will allow you to congure
the security settings of the HDD/SATA device. Select "Security Erase - Password" to enter
a SATA user password to erase the password and the contents previously stored in the
HDD/SATA device. Select "Security Erase - Without Password" to use the manufacturer
default password "111111111" as the SATA user password and to erase the contents of the
HDD/SATA device by using this default password. The options are Disable, Set Password,
Security Erase-Password, and Security Erase-Without Password.
Password
Use this feature to set the SATA user password, which will allow you to congure the SMCI
Security Erase settings by using the SATA user password.


P0: ST9100064ONS
HDD Password Description:
Use this feature to set, modify, and clear both HDD User Password and HDD Master
Password. An installed HDD User Password is required to enable HDD security features.
HDD Master Password can be modied only when it is successfully unlocked in POST. If
'Set HDD Password' options is grayed out, do power cycle to enable it.
HDD PASSWORD CONFIGURATION:
Security Supported: Yes
Security Enabled: No
Security Locked: No
Security Frozen: No
HDD Password Pwd Status: Not INSTALLED
HDD Master Pwd Status: INSTALLED