Supermicro X13SAE - Page 93

Chapter 4: UEFI BIOS
93
PCIe/PCI/PnP Conguration
SLOT1 PCI 33MHz OPROM
PCH SLOT2 PCI-E 3.0 X4 OPROM
PCH SLOT4 PCI-E 5.0 X8 (IN x16) OPROM
CPU SLOT5 PCI-E 3.0 X4 OPROM
CPU SLOT7 PCI-E 5.0 X16 OPROM
PCI-E M.2-M1 OPROM
PCI-E M.2-M2 OPROM
PCI-E M.2-M3 OPROM
Onboard LAN1 Option ROM
Select Disabled to deactivate the selected slot or EFI to activate the slot in UEFI mode.
The options are Disabled and EFI.
SATA And RST Conguration
SATA And RST Conguration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
conguration:
Storage Option ROM/UEFI Driver
This feature controls the execution of UEFI and legacy storage OpROM. The options are Do
not launch and EFI.
Aggressive LPM Support
This feature enables the PCH to aggressively enter link power state. The options are
Disabled and Enabled.
SATA Port0~7
Software Preserve
Hot Plug
This feature designates the port specied for hot plugging. Set the setting to Enabled for
hot-plugging support, which will allow you to replace a SATA disk drive without shutting
down the system. The options are Disabled and Enabled.