Supermicro X13SRA-TF - Page 100

Super X13SRA-TF User's Manual
100
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The options
are “+” and “-”.
TMUL Ratio O󰀨set
Enter a value for TMUL ratio o󰀨set. The range is 0 – 31.The default is 0 (no o󰀨set).
TjMax Override
Enter a value for TjMax ratio override. The range is 105 – 115.The default is 0 (no override).
Per Core Ratio Override
This feature enables CPU per core ratio overriding. When enabled, it sets the maximum
overclocking ratio to specic core by OCMB 0x1D command. When disabled, it sets the
ratio to all cores by OCMB command 0x11. Please note that you should manually change
the "Turbo Ratio Limit (TRL) MSR 0x1AD / 0x1AE" setting based on the setting here. The
options are Disabled and Enabled.
Mesh/Ring
Mesh (Ring) Max OC Ratio
Enter a value for the maximum overclock ratio for CPU Mesh (Ring) domain. The default is 0.
Mesh (Ring) Min OC Ratio
Enter a value for the minimum overclock ratio for CPU Mesh (Ring) domain. The default is 0.
Mesh (Ring) Voltage Mode
Use this feature to select the CPU Mesh (Ring) voltage mode. In adaptive mode, the voltage
is interpolated only in turbo mode. In override mode, the voltage selected will be applied
over all operating frequencies. The options are Adaptive and Override.
Mesh (Ring) Extra Turbo Voltage (Available when "Mesh [Ring] Voltage Mode is set
to Adaptive)
Use this feature to specify the extra turbo voltage applied (in mV) while Mesh (Ring) is
operating in turbo mode. The range is 0 – 2050 and the default is 0.
Mesh Ring Voltage Override (Available when "Mesh [Ring] Voltage Mode is set to
Override)
Use this feature to specify the override voltage applied to the Mesh (Ring) domain (in mV).
The range is 0 – 2050 and the default is 0.
Mesh (Ring) Voltage O󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the Mesh (Ring) domain.
The default is 0.