Supermicro X13SRA-TF - Page 102

Super X13SRA-TF User's Manual
102
CPU Vccin Voltage Level (Available when "SVID Support" is set to Disabled)
Use this feature to specify the VID value for CPU VccIn voltage level. The range is 500mV
to 3040mV. The default is 1800.
FIVR Faults
Use this feature to enable or disable Fully-Integrated Voltage Regulators (FIVR) faults.
When FIVR faults are disabled, OVP and OCP protection mechanisms will be masked.
The options are Disabled and Enabled.
Warning: There is a risk of disabling this setting and you shall be solely responsible for
disabling this settings.
FIVR E󰀩ciency Management
Use this feature to enable or disable FIVR e󰀩ciency management. Enabling this feature
is good for power delivery e󰀩ciency, but it may be an impediment to proper power delivery
control under overclocking, particularly BCLK overclocking. The options are Disabled and
Enabled.
Voltage PLL Trim Controls
Core PLL Voltage O󰀨set / RING PLL Voltage O󰀨set / Memory Controller PLL
Voltage O󰀨set
Enter a desired value for each feature. This feature can be used to increase the range of
this domain frequency in extreme overclocking conditions. The range is 0 – 63 in the units
of 17.5mV. The default is 0.
Overclocking
Extreme Edition
Use this feature to enable extreme edition support. The options are Disabled and Enabled.
Overclocking Clock
This feature enables overclocking lock. The options are Disabled and Enabled.
CurrentTurboRatioLimit#
Current turbo ratio limit is displayed.
TurboRatioLimit#
This feature allows you to specify the turbo ratio limit. The default is 0.
CurrentTurboRatioCores#
Current turbo ratio of the core is displayed.