Supermicro X13SRA-TF - Page 109

Chapter 4: UEFI BIOS
109
Flow Control
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None and Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Select Enabled to enable VT-UTF8 Combination Key support for ANSI/VT100 terminals.
The options are Disabled and Enabled.
Recorder Mode
Select Enabled to capture the data displayed on a terminal and send it as text messages
to a remote server. The options are Disabled and Enabled.
Resolution 100x31
Select Enabled for extended-terminal resolution support. The options are Disabled and
Enabled.
Putty KeyPad
This feature selects Function Keys and KeyPad settings for Putty, which is a terminal
emulator designed for the Windows OS. The options are VT100, LINUX, XTERMR6, SCO,
ESCN, and VT400.
Legacy OS Redirection Resolution
Use this feature to select the numbers of rows and columns used in Console Redirection
for Legacy OS support. The options are 80x24 and 80x25.
Redirection After BIOS POST
Use this feature to enable or disable legacy console redirection after BIOS POST. When
the option - BootLoader is selected, legacy console redirection is disabled before booting
the OS. When the option - Always Enable is selected, legacy console redirection remains
enabled upon OS bootup. The options are Always Enable and BootLoader.
SOL/COM2
Note: This feature is available when your system supports serial port of SOL and/or
COM2. The "SOL/COM2" here indicates a shared serial port, and SOL is used as the
default.
Console Redirection
Select Enabled to use the SOL/COM2 port for Console Redirection. The options are Disabled
and Enabled.