Supermicro X13SRA-TF - Page 116

Super X13SRA-TF User's Manual
116
NVMe Firmware Source
Use this feature to select the NVMe rmware to support system boot. The options are Vendor
Dened Firmware and AMI Native Support. The default option, Vendor Dened Firmware,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is o󰀨ered by the BIOS with a generic method.
VGA Priority
Use this feature to select the graphics device to be used as the primary video display for
system boot. The options are Onboard and O󰀨board.
Onboard Video Option ROM
Select EFI to allow you to boot the computer using the Extensible Firmware Interface (EFI)
device installed on the onboard video port. The options are Disabled and EFI.
PCH SLOT1 PCIe 5.0 X4 OPROM / CPU SLOT2 PCIe 5.0 X16 OPROM / CPU SLOT4
PCIe 5.0 X16 OPROM / CPU SLOT6 PCIe 5.0 X16 OPROM / M.2 C01 OPROM / M.2
C02 OPROM
Select EFI to allow you to boot the computer using the EFI device installed on the PCIe slot
specied. The options are Disabled and EFI.
Onboard LAN1 Option ROM
Use this feature to select which rmware function to be loaded for onboard LAN1. The options
are Disabled and EFI.
HTTP Boot Conguration
HTTP Boot Policy
Use this feature to set the HTTP boot policy. The options are Apply to all LANs, Apply to
each LAN, and Boot Priority #1 instantly.
HTTPS Boot Checks Hostname
Enable this feature for HTTPS boot to check the hostname of the TLS certicates to see if it
matches the host name provided by the remote server. The options are Enabled and Disabled
(WARNING: Security Risk!!).
Priority of HTTP Boot
Instance of Priority 1 (Available when your motherboard supports this feature)
This feature sets the rank target port. The default setting is 1.
Select IPv4 or IPv6
This feature species which connection the target LAN port should boot from. The options
are IPv4 and IPv6.