Supermicro X13SRA-TF - Page 130

Super X13SRA-TF User's Manual
130
When SEL is Full (Available when "SEL Components" is set to Enabled)
This feature allows you to determine what the BIOS should do when the system event log
is full. Select Erase Immediately to erase all events in the log when the system event log is
full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for the changes
to take e󰀨ect.
BMC Network Conguration
Update BMC LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes upon next system boot.
The options are No and Yes.
********************************
Congure IPv4 Support
******************************
IPMI LAN Selection
This feature displays the type of the IPMI LAN.
IPMI Network Link Status:
This feature displays the status of the IPMI network link for this system.
Conguration Address Source (Available when "Update BMC LAN Conguration" is
set to Yes)
Use this feature to select the source of the IPv4 connection. If Static is selected, you will
need to know the IP address of IPv4 connection and enter it to the system manually in the
eld. If DHCP is selected, the BIOS will search for a Dynamic Host Conguration Protocol
(DHCP) server in the network that is attached to and request the next available IP address
for this computer. The options are Static and DHCP.
Station MAC Address (Available when "Conguration Address Source" is set to
Static)
This feature displays the Station MAC address for this computer. Mac addresses are six
two-digit hexadecimal numbers.
Station IP Address (Available when "Conguration Address Source" is set to Static)
This feature displays the Station IP address in decimal and in dotted quad form (i.e.,
172.29.176.131).