28
Super X13SRA-TF User's Manual
Installing the Processor Heatsink Module
After assembling the Processor Heatsink Module (PHM), install it onto the CPU socket:
1. Align pin 1 of the PHM with the printed triangle on the CPU socket. See the left image
below.
2. Make sure all four holes of the heatsink are aligned with the socket, then gently place
the heatsink on top of the CPU socket.
3. Press all four rotating wires outwards and make sure that the heatsink is securely
latched into the CPU socket.
4. With a T30 Torx-bit screwdriver, gradually tighten the four screws to ensure even
pressure. You can start with any screw, but make sure to tighten the screws in a
diagonal pattern. To avoid damaging the processor or socket, do not use a force greater
than 8 in-lbf when tightening the screws.
5. Examine all corners to ensure that the PHM is rmly attached to the socket.
T30 Torx Screwdriver
Use a torque
of 8 in-lbf
Airflow direction
Printed
Triangle
Mount the Processor Heatsink Module
onto the CPU socket (on the motherboard).
Press the rotating wires outwards to latch
the PHM and then tighten the four screws.
To Next Page
Loading...
