Supermicro X13SRA-TF - Page 38

38
Super X13SRA-TF User's Manual
2280 M.2 Device Installation
1. Locate the pre-installed stando󰀨 on the 22110
mounting hole. Remove the stando󰀨 screw
and set it aside.
2. Using a hex socket screwdriver, remove and
then re-install the stando󰀨 to the position of
the 2280 mounting hole.
3. Insert the M.2 device or the heatsink assembly into the M.2 socket at a 30-degree angle
and press it down.
4. Tighten the stando󰀨 screw to secure the M.2 device or the heatsink assembly into place.
Do not overtighten so as to avoid damaging the M.2 device.
Standard M.2 device M.2 device with Supermicro heatsink
Standard M.2 device M.2 device with Supermicro heatsink