Supermicro X13SRA-TF - Page 67

67
Chapter 2: Installation
LAN Port Enable/Disable
JPL1 and JPL2 allow you to enable the onboard LAN ports (LAN1 and LAN2). The default
setting is pins 1-2 to enable the connections. Refer to the table below for jumper settings.
LAN Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enable
Pins 2-3 Disable
ME Manufacturing Mode
JPME2 is used for ME Firmware Recovery mode, which will limit system resource for essential
function use only without putting restrictions on power use. In the single operation mode,
online upgrade will be available via Recovery mode. Refer to the table below for jumper
settings.
ME Recovery
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal (Default)
Pins 2-3 ME Manufacturing Mode
1. LAN1 Enable/Disable (JPL1)
2. LAN2 Enable/Disable (JPL2)
3. ME Manufacturing Mode (JPME2)
1
2
BAR CODE BAR CODE
IPMI CODE
MAC CODE MAC CODE SAS CODE
JTPM1
SP1
USB9 (3.2)
(USB3.2 GEN2X2)
UID-LED
JPI2C1
M.2-C01 LED
M.2-C02 LED
JF1
JWD1
JPL1
JPUSB1
JPL2
JSD1
FAN2
HD AUDIO
AUDIO FP
JUIDB1
LED8
COM1
USB0/1
FANB
FANC
BATTERY
DIMME2 DIMMF2 DIMMF1 DIMME1
DIMMA2 DIMMA1 DIMMB2 DIMMB1
SATA 1
SATA 0
SATA 3
SATA 2
SATA 4
SATA 5
M.2-C01
M.2-C02
JPME2
JL1
JRK1
(RAID Key Header)
JCMOS
JBT1
JPW2
JPW3
FAN1
FANA
JSTBY1
CPU SLOT6 PCIe 5.0 X16
JOH1
JPW1
12V_ PUMP_PWR1
USB8
(USB3.2 GEN2X2)
VGA
CPU SLOT4 PCIe 5.0 X16
PCH SLOT1 PCIe 4.0 X4
CPU SLOT2 PCIe 5.0 X16
BMC LED
JSPDIF_OUT
JPAC1
CPU
PCH
BIOS LICENSE
LAN
CTRL
BMC
USB6/7
(USB3.2 GEN2)
LAN1
USB4/5
(USB3.2 GEN2)
LAN2
Power LED
(PCIe 5.0 X4)
(PCIe 5.0 X4)
X13SRA-TF
DESIGNED IN USA
REV:1.01
JD1
(SPEAKER 1-4)
USB2/3 (3.0)
(USB3.2 GEN1)
LAN
CTRL
3